UK and WORLDWIDE INTERNATIONAL SHIPPING DAILY

THE LONDON BROW LAMINATION PROCEDURE: 

Our Procedure is for The London Brow Lamination    Products Only

Read all Instructions & Important Information below before starting treatment.

Before starting make sure you place a barrier around your clients brow (vaseline is a good barrier).  This will protect your clients skin from any perm solution.  

1. Apply London Brow Lift - Step 1  to one brow at a time. Take care to keep the perm solution to hair area only avoiding tips. Cover brows with cling wrap. 
See The London Brow  Timing and Hair Type Guide below for how long to leave Step 1 on the brows.

2. After leaving Step 1 on for the necessary time, remove the cling wrap and then by using a WET cotton pad, remove all the solution in an upwards motion leaving no residue.   Be gentle with the brows they are fragile. Once clean, apply Step 2 - London Brow Neutraliser Creme to both brows together. Be generous you need to ensure all brow hair is covered and neutralised correctly to keep brow hair safe.Cover again using your cling wrap again to fix the hairs into place.   

3. After leaving Step 2 on for 6 - 8 minutes, remove cling wrap then remove all the solution in an upwards motion using a cotton bud or cotton pad.  Set the brows into your desired shape.
Tint (if necessary) and Wax  

4. Apply Step 3 - London Brow Nourish Creme to both brows. Use a generous amount to ensure this is applied to the hair and skin. Leave Step 3 - Brow Keratin Nourish on the brows for the client to leave with. 

5. Retail The London Brow Keratin Boost to your client and instruct them to nourish the hair and skin daily.  

TIMING:

Step 1: 2 - 8  minutes (Spot apply thereafter if necessary) 

Step 2: 6 - 8 Minutes  

Step 3: Client to leave on for minimum 12 hours to keep brows locked in place

Thereafter use London Brow Keratin Boost daily or weekly as needed

HAIR TYPE GUIDE:

Thin or Fine Brow Hairs: 2 - 4  Minutes  

Medium or Normal Brow Hairs: 3 - 6  

Minutes Coarse of Stubborn Hairs: 4 - 8   Minutes  

IMPORTANT:

• Tint and other Hanna colour develop much faster after lamination due to porous hair.  Ensure you reduce your timings and colour (if your client normally has dark brown use medium brown) watch the colour development closely.
• Tinting is not always necessary and is not recommended if clients want to keep the natural "fluffy" look.  Tinting can make the eyebrow look too bold and harsh.
• Brow Lamination must always be performed before waxing, threading or plucking treatments. IF performing this service after to tidy brows your insurance will be invalid if in the UK.
• Do not apply scrubs to the eyebrow area before lamination.  Leave 3 - 4 days after waxing brows.
• Never use the same applicator to apply Step 1 and Step 2. You must use two separate disposable brushes for both steps.
• In case of contact with eyes, wash immediately with distilled water.

HOW BROW LAMINATION WORKS: 

Step 1 When the Brow Perming Solution is applied, a chemical process breaks down the bonds within each hair, allowing them to become flexible to be positioned into a new shape.   

Step 2 When the Brow Neutraliser (Fixing) Solution is applied, the hair bonds (Disulphide bonds) rejoin and reform into the new shape.   

Step 3 The Brow Nourishing Serum is applied at the end of the treatment to restore moisture back into the brows and skin.   The serum also locks the brows into place for the next 48 hours.  

NOTE: The new brow design and shape takes up to 48 hours for the bonds to reform and lock into place.  It is important to stress that your client follows the correct aftercare for 48 hours post-treatment as well as the duration of their brow perm. 

BROW LAMINATION CLIENT AFTERCARE: 

Important Aftercare for 24 - 48 hours post treatment and for the duration of the brow perm.

• Keep brows dry for 48 hours.
• Use London Brow Keratin Brow Boost Oil daily (Post 12 - 24 hours)
• Do not apply make-up for at least 24 hours after your treatment.
• Avoid swimming/sauna/working out for 24-48 hours. Any excess moisture after this time can cause a slight curl/frizz to the brow hair.
• Do not allow prolonged exposure to direct sunlight or heat.
• Do not apply Retin-A, AHA or exfoliate around the brow area for 72 hours either side of the treatment.
• No self-tanning products should be used on the face for one week prior and 48 hours after treatment. 

NOTE: If any stinging or swelling occurs, apply a cold compress to the area and seek medical advice.